Volume 21 (2024)
Volume 20 (2023)
Volume 19 (2022)
Volume 18 (2021)
Volume 17 (2020)
Volume 16 (2019)
Volume 15 (2018)
Volume 14 (2017)
Volume 13 (2016)
Volume 12 (2015)
Volume 11 (2014)
Volume 10 (2013)
Volume 9 (2012)
Volume 8 (2011)
Volume 7 (2010)
Volume 6 (2009)
Volume 5 (2008)
Volume 4 (2007)
Volume 3 (2006)
Volume 1 (2004)
Full article Separation Technology,
Experimental Comparison of Two Modifications of Activated Sludge for Treatment of Furfural-Containing Wastewater
Volume 2, Issue 1 , January 2005, Pages 3-9

Abstract
   A case study is presented in which two modifications of activated sludge treatment of complex chemical wastewater are experimentally compared: a combination of common activated sludge with powdered activated carbon treatment (PACT), and bioaugmentation of activated sludge treatment (BAST). Industrial ...  Read More

Full article Separation Technology,
The Effects of Operational Parameters on the Efficiency of a Mixer-Settler Extractor
Volume 2, Issue 1 , January 2005, Pages 10-23

Abstract
  The effects and influences of various operational parameters on the efficiency of mixer-settlers are thoroughly studied in this paper. One of the most important factors in designing a mixer-settler is to obtain an optimum operational extraction and overall efficiency. These two factors are dependent ...  Read More

Full article Modeling and Simulation
A New Model for Prediction of Heat Eddy Diffusivity in Pipe Expansion Turbulent Flows
Volume 2, Issue 1 , January 2005, Pages 24-33

Abstract
  A new model to calculate heat eddy diffusivity in separating and reattaching flows based on modification of constant Prt is proposed. This modification is made using an empirical correlation between maximum Nusselt number and entrance Reynolds number. The model includes both the simplicity of Prt=0.9 ...  Read More

Full article Modeling and Simulation
Investigation of CO2 and H2O Addition to Natural Gas for Production of Synthesis Gas
Volume 2, Issue 1 , January 2005, Pages 31-54

Abstract
  General modeling and optimization of syngas production via noncatalytic autothermal partial oxidation of methane are carried out using our developed scientific software which was based on the minimization of total Gibbs energy. In this work, a novel application of the direct search and Newton-Raphson ...  Read More

Full article Modeling and Simulation
Dynamic Modeling of Granular Sludge in UASB Reactors
Volume 2, Issue 1 , January 2005, Pages 52-60

Abstract
  n this paper, a mathematical model has been derived to predict the granulation time of anaerobic sludge in UASB reactors. In the proposed model, some physical, chemical and biological parameters affecting the granulation phenomena have been considered. To validate the model, 12 pilot-scale experiments ...  Read More

Full article Environmental Engineering,
Monolithic Three-way Palladium Catalytic Converters for Automobile Exhaust Emission Control
Volume 2, Issue 1 , January 2005, Pages 61-70

Abstract
  This article presents the research results on production and performance of palladium-only catalytic converters. Monolith is used as the catalyst carrier and gamma alumina as the substrate. Dipping method is used for monolith washcoating. Palladium as the active metal is impregnated on gamma alumina ...  Read More

Full article Thermodynamics,
Prediction of Vapor-Liquid Equilibria Using CEOS /GE Models
Volume 2, Issue 1 , January 2005, Pages 71-81

Abstract
  The present study investigates the use of different GE mixing rules in cubic equations of state for prediction of phase behavior of multicomponent hydrocarbon systems. To predict VLE data in multicomponent symmetric and asymmetric mixtures such as systems that contain light gases (nitrogen, carbon dioxide, ...  Read More