Volume 18 (2021)
Volume 17 (2020)
Volume 16 (2019)
Volume 14 (2017)
Volume 13 (2016)
Volume 12 (2015)
Volume 11 (2014)
Volume 10 (2013)
Volume 9 (2012)
Volume 8 (2011)
Volume 7 (2010)
Volume 6 (2009)
Volume 5 (2008)
Volume 4 (2007)
Volume 3 (2006)
Volume 2 (2005)
Volume 1 (2004)
Full article Separation Technology,
1. Extraction of pectin from sour orange and its application as the adsorbent for removal of nickel from aqueous solution: Kinetic and equilibrium study

N. Kakoui; M. Nikzad; A. A. Ghoreyshi; M. mohammadi

Volume 15, Issue 2 , Spring 2018, Pages 3-21

Abstract
  The present study investigates the potential applicability of the extracted pectin from sour orange pomace as adsorbent for Ni (II) removal from aqueous solution. Pectin extraction from the pomace was carried out using HCl and the highest pectin extraction yield of 26.75% was obtained. The Fourier transform ...  Read More

Full article Modeling and Simulation
2. CFD modeling for selective formation of propylene from methanol over synthesized Mn-substituted MFI metallosilicate catalyst

N. Hadi; A. Niaei; r. alizadeh

Volume 15, Issue 2 , Spring 2018, Pages 22-37

Abstract
  The high silica Mn-substituted MFI metallosilicate catalyst with Si/Al molar ratio of 220 and Si/Mn molar ratio of 50 was successfully synthesized by hydrothermal method. The catalyst sample was appropriately characterized by XRD, FE-SEM, EDX and BET techniques. The Mn-substituted MFI metallosilicate ...  Read More

Full article Reaction Engineering, Kinetics and Catalysts,
3. Hydroconversion of Furfural over Cu-Cr/SiO2 Nanocatalysts: A Comparative Study

M. Ghashghaee; S. Shirvani; V. Farzaneh

Volume 15, Issue 2 , Spring 2018, Pages 38-51

Abstract
  Furfural is one of the most promising chemical platforms with bright perspective with respect to the production of biobased chemicals and fuels from lignocellulosic material. Globally, the majority of this biomass derived chemical is converted into furfuryl alcohol, a building block in polymers industry. ...  Read More

Full article Reaction Engineering, Kinetics and Catalysts,
4. Optimization of Semiregenerative Catalytic Naphtha Reforming Unit to Enhance Octane Number and Reformate Yield

I. Khosrozadeh; M.R. Talaghat; A.A. Roosta

Volume 15, Issue 2 , Spring 2018, Pages 52-64

Abstract
  Catalytic naphtha reforming is one of the most important processes in which, low quality naphtha is converted into high octane motor gasoline. In this study, a mathematical model was developed and was used for investigation the effect of temperature, pressure, hydrogen to hydrocarbon ratio on the octane ...  Read More

Full article Separation Technology,
5. Fabrication of Chitosan-Polyethylene Oxide Electrospun Nanofibrous Mats Containing Green Tea Extract

A. Barzegari; Z. Shariatinia

Volume 15, Issue 2 , Spring 2018, Pages 65-77

Abstract
  Novel electrospun nanofibrous CS-PEO nerve conduits containing 0, 2.5 and 5% of green tea methanolic extract were developed and characterized by FE-SEM, FT-IR, TGA/DSC as well as tensile strength analysis. The FE-SEM images revealed that all of the nanofibers had an average diameter of ∼80nm. The ...  Read More

Full article Modeling and Simulation
6. Predicting the coefficients of the Daubert and Danner correlation using a neural network model

k. movagharnejad; F. Saffar

Volume 15, Issue 2 , Spring 2018, Pages 78-90

Abstract
  In the present research, three different architectures were investigated to predict the coefficients of the Daubert and Danner equation for calculation of saturated liquid density. The first architecture with 4 network input parameters including critical temperature, critical pressure, critical volume ...  Read More

Research note Reaction Engineering, Kinetics and Catalysts,
7. Experimental and Kinetic Study of CO Oxidation Over LaFe1-xCuxO3 (x=0, 0.2, 0.4, 0.6) Perovskite-Type Oxides

P. Rashidi Zonouz; M.E. Masoumi; A. Niaei; A. Tarjomannejad

Volume 15, Issue 2 , Spring 2018, Pages 91-102

Abstract
  In this paper, catalytic oxidation of CO over the LaFe1-xCuxO3 (x= 0, 0.2, 0.4, 0.6) perovskite-type oxides was investigated. The catalysts were synthesized by sol-gel method and characterized by XRD, BET, FT-IR, H2-TPR and SEM methods. The catalytic activity of catalysts was tested in catalytic oxidation ...  Read More