Energy
A. Hemmati; T. Abedzadegan
Volume 16, Issue 1 , March 2019, , Pages 70-83
Abstract
Different methods of urban sewage sludge energy recovery such as burning, gasification, pyrolysis and digestion based on the net energy production efficiency, advantages and disadvantages and complexity of these processes have been investigated in this article. The best method for energy production from ...
Read More
Different methods of urban sewage sludge energy recovery such as burning, gasification, pyrolysis and digestion based on the net energy production efficiency, advantages and disadvantages and complexity of these processes have been investigated in this article. The best method for energy production from sludge was selected among different methods according to energy and the amount of the greenhouse gas production. The capacity of the constructed power plant was calculated and investigated economically for each scenario. Quantitative and qualitative information on sludge was required to carry out this research so Ekbatan wastewater treatment sludge was analyzed. The results showed that the sludge of this treatment plant has 5.7% solids, containing 65.7% volatiles and the dry heat value is about 15100 kJ/kg. It was found that the best scenario for sludge energy production in this treatment plant is a digestion process with pure net energy production of 73.2 × 107 kJ/d. The energy recovery in an anaerobic digester can prevent the emission of 16,680 tons of CO2 annually and release about 1,460 tons of CO2 per year. The chemical analysis shows that the selected sludge has a potential production of 25m3 of CH4 for each m3 of sludge. The annual amount of biogas that can be recovered from municipal treatment plant is 836543 m3. On the other hand, the biogas can be used to generate electricity. The power of the plant is about 216.8 kW that with the construction of this power plant, an annual saving of 1.5 million dollars will occur.
Modeling and Simulation
E. Pashai; M. R. Dehghani; F. Feyzi
Volume 14, Issue 2 , 2017, , Pages 33-47
Abstract
Varnish and sludge formation are considered as one of the most common problems in lubrication and hydraulic systems. In order to simulate the condition of sludge formation, base stock lubricant (Group 1 API) has been selected and exposed to heat in a laboratory setup. Sludge formation process accelerated ...
Read More
Varnish and sludge formation are considered as one of the most common problems in lubrication and hydraulic systems. In order to simulate the condition of sludge formation, base stock lubricant (Group 1 API) has been selected and exposed to heat in a laboratory setup. Sludge formation process accelerated in the laboratory scale and solid liquid equilibrium data were extracted. Then solid-liquid equilibrium has been modeled using SAFT equation of state through sludge formation. The results for prediction of sludge formation showed that the absolute average deviations between experimental and theoretical results were less than 1.4%. The calculated results for solubility coefficient of the oxidation byproducts from SN100 (solvent neutral Group I) base stock in fresh (un-oxidized) oil were in good agreement with the experimental data, and average deviation between calculated and experimental data was less than 6.5%. The amount obtained for binary interaction parameter K_ij was – 0.0447. It is shown that SAFT equation of state has the capability of solid liquid equilibrium.