Environmental Engineering,
A. Es,Hagi; H. Hazrati
Abstract
The membrane bioreactor (MBR) is a combination of biological and membrane systems. It utilizes advanced technologies in the treatment of various types of wastewater, having unique advantages such as the high-quality effluent and improved efficiency. The primary limiting factor for the utilization of ...
Read More
The membrane bioreactor (MBR) is a combination of biological and membrane systems. It utilizes advanced technologies in the treatment of various types of wastewater, having unique advantages such as the high-quality effluent and improved efficiency. The primary limiting factor for the utilization of this bioreactor is the membrane fouling phenomenon, which increases operational costs. In this study, four membrane bioreactors were used, with the first MBR (R1) serving as the control bioreactor. In the second MBR (R2), an adsorption process was employed, while in the third (R3) and fourth MBR (R4), in addition to the adsorption process, the electrochemical process was applied with voltages of two and one volts respectively. For the four bioreactors, the percentages of the Chemical Oxygen Demand (COD) were recorded as 86%, 91.2%, 90.7%, and 95.3% respectively. The levels of the total Extracellular Polymeric Substances (EPS) in R1, R2, R3, and R4 were about 260, 155, 177, and 98 mg/gVSS respectively. The R4 exhibited significantly lower EPS (98 mg/gVSS) compared to R1 (260 mg/gVSS), possibly due to the adsorption of EPS by nanoparticles and its subsequent removal during the electrochemical process. The role of voltage was evident in R3, where the higher voltage (2V) resulted in the less removal of EPS (155 mg/gVSS) compared to the same in R4 (98 mg/gVSS). The study found that the values of the Soluble Microbial Products (SMP) for R4, R3, R2, and R1 were about 15, 65, 55 and 139 mg/L respectively. Particularly in the most effective MBR, R4, where the addition of the zeolite adsorbent alongside metal ions demonstrated the best performance in the removal of SMP.
Environmental Engineering,
M. Ghanbarnezhad; A. Parvareh; M. Moraveji; S. Jorfi
Abstract
The Fe3O4/MW-CNT composite was prepared for a hybrid photo-catalyst-assisted electrochemical process for the removal of BTX contamination from wastewater. Oxidation of multi-walled carbon nanotube was conducted by different treatments including acid treatment and hydrogen peroxide. The XRD, FTIR, SEM, ...
Read More
The Fe3O4/MW-CNT composite was prepared for a hybrid photo-catalyst-assisted electrochemical process for the removal of BTX contamination from wastewater. Oxidation of multi-walled carbon nanotube was conducted by different treatments including acid treatment and hydrogen peroxide. The XRD, FTIR, SEM, TEM, and BET analyses were performed to characterize both the MW-CNT and the synthesized composite. Simultaneous photo-catalyst and electrochemical processes were conducted to evaluate the performance of a new hybrid process for wastewater treatment. The effect of current density, photo-catalyst loading, and BTX initial concentration was investigated experimentally. The characterization results of the synthesized composite show that a mixture of strong nitric acid and sulfuric acid treatment at a high exposure time and low temperature is the best route for MW-CNT oxidation. The removal efficiency of BTX compounds from wastewater using the hybrid photo-electrochemical process was found to be in the range of 28 to 43% for different conditions. The optimum condition for maximum removal of BTX was found by mathematical modeling of experimental data. The results indicate that a combination of photo-catalyst and the electrochemical process can enhance the BTX removal efficiency.