[1] Beigzadeh, R., Parvareh, A. and Rahimi, M., “Experimental and CFD study of the tube configuration effect on the shell-side thermal performance in a shell and helically coiled tube heat exchanger”, Iran J. Chem. Eng., 12 (2), 13 (2015).
[2] Karale, C. M., Bhagwat, S. S. and Ranade, V. V., "Flow and heat transfer in serpentine channels", AIChE J., 59 (5), 1814 (2013).
[3] Ozbolat, V., Tokgoz, N. and Sahin, B., “Flow characteristics and heat transfer enhancement in 2D corrugated channels”, Int. J. Mech. Sci. Eng., 7 (10), 796 (2013).
[4] Arvanitis, K. D., Bouris, D. and Papanicolaou, E., “Laminar flow and heat transfer in U-bends: The effect of secondary flows in ducts with partial and full curvature”, Int. J Therm. Sci., 130, 70 (2018).
[5] Takamura, H., Ebara, S., Hashizume, H., Aizawa, K. and Yamano, H., “Flow visualization and frequency characteristics of velocity fluctuations of complex turbulent flow in a short elbow piping under high Reynolds number condition”, J. Fluids Eng., 134 (10), 101201 (2012)
[6] Kim, J., Yadav, M. and Kim, S., “Characteristics of secondary flow induced by 90-degree elbow in turbulent pipe flow”, Eng. Appl. Comp. Fluid Mech., 8 (2), 229 (2014).
[7] Sheikholeslami, M., Gerdroodbary, M. B., Mousavi, S. V., Ganji, D. D. and Moradi, R. “Heat transfer enhancement of ferrofluid inside an 90 elbow channel by non-uniform magnetic field”, J. Magn. Magn. Mater, 460, 302 (2018).
[8] Naphon, P. and Wongwises, S., “A review of flow and heat transfer characteristics in curved tubes”, Renew. Sustain. Energy Rev., 10 (5), 463 (2006).
[9] Wang, J., Wang, S., Zhang, T. and Battaglia, F., “Numerical and analytical investigation of ice slurry isothermal flow through horizontal bends”, Int. J. Refrig., 92, 37 (2018).
[10] Kalpakli, A. and Örlü, R., “Turbulent pipe flow downstream a 90 pipe bend with and without superimposed swirl”, Int. J. Heat Fluid Flow, 41, 103 (2013).
[11] Khoshvaght-Aliabadi, M., Khaligh, S. F. and Tavassoli, Z., “An investigation of heat transfer in heat exchange devices with spirally-coiled twisted-ducts using nanofluid”, Appl. Therm. Eng., 143, 358 (2018).
[12] Ngo, T. L., Kato, Y., Nikitin, K. and Ishizuka, T., “Heat transfer and pressure drop correlations of microchannel heat exchangers with S-shaped and zigzag fins for carbon dioxide cycles”, Exp. Therm. Fluid Sci., 32 (2), 560 (2007).
[13] Zheng, Z., Fletcher, D. F. and Haynes, B. S., “Chaotic advection in steady laminar heat transfer simulations: Periodic zigzag channels with square cross-sections”, Int. J. Heat Mass Transf., 57 (1), 274 (2013).
[14] Moraveji, M. K. and Beheshti, A. R., “CFD study of the turbulent forced convective heat transfer of non-newtonian nanofluid”, Iran J. Chem. Eng., 11 (2), 92 (2014).
[15] Beigzadeh, R., “The CFD provides data for adaptive neuro-fuzzy to model the heat transfer in flat and discontinuous fins”, Iran J. Chem. Eng., 16 (2), 57 (2019).
[16] Cui, X., Guo, J., Huai, X., Zhang, H., Cheng, K. and Zhou, J., “Numerical investigations on serpentine channel for supercritical CO2 recuperator”, Energy, 172, 517 (2019).
[17] Rahimi, M., Shabanian, S. R. and Alsairafi, A. A., “Experimental and CFD studies on heat transfer and friction factor characteristics of a tube equipped with modified twisted tape inserts”, Chem. Eng. Process, 48 (3), 762 (2009).
[18] Taler, D. and Taler, J., “Simple heat transfer correlations for turbulent tube flow”, In E3S Web of Conferences, EDP Sciences, Vol. 13, 02008 (2017).
[19] Ahsan, M., “Numerical analysis of friction factor for a fully developed turbulent flow using k–ε turbulence model with enhanced wall treatment”, Beni Suef Univ. J. Basic Appl. Sci., 3 (4), 269 (2014).
[20] Dutta, P., Saha, S. K., Nandi, N. and Pal, N., “Numerical study on flow separation in 90 pipe bend under high Reynolds number by k-ε modelling”, Eng. Sci. Technol. Int. J., 19 (2), 904 (2016).
[21] Rahimi, M., Beigzadeh, R., Parvizi, M. and Eiamsa-ard, S., “GMDH-type neural network modeling and genetic algorithm-based multi-objective optimization of thermal and friction characteristics in heat exchanger tubes with wire-rod bundles”, Heat Mass Transf., 52 (8), 1585 (2016).