Process Design and Simulation Research Center, Department of Chemical Engineering, University of Tehran, Iran
Abstract
A mathematical model is developed for describing the dynamic behavior of the gas phase ethylene polymerization reactor. The model is based on the dynamic two-phase concept of fluidization in which the bubbles may contain solid particles and the emulsion is capable of containing more gas than that of minimum fluidization. The fluidized bed reactor is divided into several serial sections consisting of bubble and emulsion phases. Flow of the gas is considered as plug flow through the bubbles and perfectly mixed through the emulsion phase. Polymerization reactions occur in both emulsion and bubble phases. Variation of the process variables as well as the polymer properties were studied as a function of operating time. The bed height was controlled by the product withdrawal rate with a PID controller. The results of the model were compared with the experimental data and a good agreement was observed between the model prediction and actual data. The simulation results indicate that a significant amount of polymer production (roughly 12%) takes place in the bubbles.
Hassimi,A. , Mostoufi,N. and Sotudeh-Gharebagh,R. (2009). Unsteady-State Modeling of the Fluidized Bed Polyethylene Reactor. Iranian Journal of Chemical Engineering (IJChE), 6(1), 23-39.
MLA
Hassimi,A. , , Mostoufi,N. , and Sotudeh-Gharebagh,R. . "Unsteady-State Modeling of the Fluidized Bed Polyethylene Reactor", Iranian Journal of Chemical Engineering (IJChE), 6, 1, 2009, 23-39.
HARVARD
Hassimi A., Mostoufi N., Sotudeh-Gharebagh R. (2009). 'Unsteady-State Modeling of the Fluidized Bed Polyethylene Reactor', Iranian Journal of Chemical Engineering (IJChE), 6(1), pp. 23-39.
CHICAGO
A. Hassimi, N. Mostoufi and R. Sotudeh-Gharebagh, "Unsteady-State Modeling of the Fluidized Bed Polyethylene Reactor," Iranian Journal of Chemical Engineering (IJChE), 6 1 (2009): 23-39,
VANCOUVER
Hassimi A., Mostoufi N., Sotudeh-Gharebagh R. Unsteady-State Modeling of the Fluidized Bed Polyethylene Reactor. IJChE, 2009; 6(1): 23-39.
