Document Type : Full length

Authors

1 Faculty of Petroleum and Chemical Engineering, Razi University, Kermanshah, Iran.

2 Faculty of Chemical Engineering, Urmia University of Technology, Urmia, Iran

Abstract

In this study, hydrodynamic characteristics such as gas holdup (ε), liquid phase velocity, and mass transfer coefficient (kLa) for air-diesel system were modeled for bubble column (BCR), airlift (ALR), and airlift with the net draft tube (ALR-NDT) reactors at different superficial gas velocities ranging from 0.008 to 0.085 m s-1. A 3D two-fluid Eulerian-Eulerian model was developed using computational fluid dynamic (CFD) technique to model the three configurations of column reactors and predict the hydrodynamic parameters. The results of 3D-CFD modeling showed a good agreement with the experimental data where average error was less than 14 and 9% for ε and kLa, respectively. Although the vortex occurred in BCR and ALR at high gas velocities, however optimum liquid and gas circulation and distribution observed in ALR-NDT. Furthermore, the formation of dead zone (kLa = 0) in the reactors was studied, and the results revealed that ALR-NDT has a lower volume of dead zones (about 8%) in comparison with BCR and ALR. In order to reduce the dead zone in BCR and ALR systems, the location of gas diffuser and draft tube were investigated. The dead zone was decreased by 12% with shifting of gas diffuser to the bottom of the BCR. Also, by increasing the distance of gas diffuser from draft tube, the dead zone was decreased by 40% specifically near the walls of ALR. Meanwhile, the simultaneous shifting of gas diffuser and draft tube to lower position in ALR had no effect on dead zone formation and its distribution.

Keywords

[1]      Kantarci, N., Borak, F. and Ulgen, K. O., “Bubble column reactors”, Process Biochem., 40 (7), 2263 (2005). (https://doi:10.1016/j.procbio.2004.10.004).
[2]      Behin, J., “Modeling of modified airlift loop reactor with a concentric double-draft tube”, Chem. Eng. Res. Des., 88 (8), 919 (2010). (https://doi.org/10.1016/j.cherd.2010.01.004).
[3]      Flickinger, M. C. and Drew, S. W., Encyclopedia of bioprocess technology, John Wiley, (1999).
[4]      Fu, C. C., Wu, W. T. and Lu, S. Y., “Performance of airlift bioreactors with net draft tube”, Enzme. Microb. Technol., 33 (4), 332 (2003). (https://doi.org/10.1016/S0141-0229(03)00151-0).
[5]      Mohebali, G. and Ball, A. S., “Biodesulfurization of diesel fuels-past, present and future perspectives”, Int. Biodeter. & Biodegrad., 110, 163 (2016). (https://doi.org/10.1016/j.ibiod.2016.03.011).
[6]      Tabib, M. V., Roy, S. A. and Joshi, J. B., “CFD simulation of bubble column-an analysis of interphase forces and turbulence models”, Chem. Eng. J., 139 (3), 589 (2008). (https://doi.org/10.1016/j.cej.2007.09.015).
[7]      Azzopardi, B., Zhao, D, Yan, Y. and Zhao D., Hydrodynamics of gas-liquid reactors: Normal operation and upset conditions, John Wiley & Sons, (2011). (https://doi.org/10.1002/9781119970712).
[8]      Lestinsky, P., Vayrynen, P., Vecer, M. and Wichterle, K., “Hydrodynamics of airlift reactor with internal circulation loop: Experiment vs. CFD simulation”, Procedia Eng., 42, 892 (2012) (https://doi.org/10.1016/j.proeng.2012.07.482).
[9]      Hekmat, A., Amooghin, A. E. and Moraveji, M. K., “CFD simulation of gas-liquid flow behaviour in an air-lift reactor: Determination of the optimum distance of the draft tube”, Simul. Model. Pract. Theory, 18 (7), 927 (2010). (https://doi.org/10.1016/j.simpat.2010.02.009).
[10]  Nalband, M. and Jalilnejad, E., “3D CFD simulation of gas hold-up and mass transfer in a modified airlift reactor with net draft tube”, Int. J. Chem. Reac. Eng., 17 (12), (2019). (https://doi.org/10.1515/ijcre-2019-0060).
[11]  Lu, X., Long, B., Ding, Y. and Deng, F., “Experimental study and CFD-PBM simulation of the unsteady gas-liquid flow in an airlift external loop reactor”, Flow Turbul. Combust., 102 (4), 1053 (2019). (https://doi.org/10.1007/s10494-018-9992-5).
[12]  Guler, B. A., Deniz, I., Demirel, Z. and Imamoglu, E., “Computational fluid dynamics simulation in scaling-up of airlift photobioreactor for astaxanthin production”, J. Biosci. Bioeng., 129 (1), 86 (2020). (https://doi.org/10.1016/j.jbiosc.2019.06.010).
[13]  Dejaloud, A., Vahabzadeh, F. and Habibi, A., “Hydrodynamics and oxygen transfer characterization in a net draft tube airlift reactor with water-in-diesel microemulsion”, Fuel Processing Technology, 171, 265 (2018). (https://doi.org/10.1016/j.fuproc.2017.11.027).
[14]  Kuzmin, D., Haario, H. and Turek S., “Finite element simulation of turbulent bubbly flows in gas-liquid reactors”, Univ. Dortmund, Fachbereich Mathematik, Dortmund, Germany, (2005).
[15]  Mahmood, K. A., Wilkinson, S. J. and Zimmerman, W. B., “Airlift bioreactor for biological applications with microbubble mediated transport processes”, Chem. Eng. Sci., 137, 243 (2015). (https://doi.org/10.1016/j.ces.2015.06.032).
[16]  Davarnejad, R., Bagheripoor, E. and Sahraei, A., “CFD simulation of scale influence on the hydrodynamics of an internal loop airlift reactor”, Sci. Res., 4 (10), 668 (2012). (https://doi.org/10.4236/eng.2012.410085).
[17]  Salehpour, R., Jalilnejad, E., Nalband, M. and Ghasemzadeh, K., “Hydrodynamic behavior of an airlift reactor with net draft tube with different configurations: Numerical evaluation using CFD technique”, Particuology, 51, 91 (2019). (https://doi.org/10.1016/j.partic.2019.09.005).
[18]  Crowe, C. T., Schwarzkopf, J. D., Sommerfeld, M. and Tsuji, Y., Multiphase flows with droplets and particles, CRC Press, (2011).
[19]  Murthy, B. and Joshi J., “Assessment of standard k–ε, RSM and LES turbulence models in a baffled stirred vessel agitated by various impeller designs”, Chem. Eng. Sci., 63 (22), 5468 (2008). (http://doi.org/10.1016/j.ces.2008.06.019).
[20]  Shaheed, R., Mohammadian A. and Gildeh, H. K., “A comparison of standard k–ε and realizable k–ε turbulence models in curved and confluent channels”, Environ. Fluid Mech., 19 (2), 543 (2019). (http://doi.org/ 10.1007/s10652-018-9637-1).
[21]  Sokolichin, A. and Eigenberger, G., “Applicability of the standard k–ε turbulence model to the dynamic simulation of bubble columns: Part I. Detailed numerical simulations”, Chem. Eng. Sci., 54 (13-14), 2273 (1999). (https://doi.org/10.1016/S0009-2509(98)00420-5).
[22]  Cockx, A., Do-Quang, Z., Line, A. and Roustan, M., “Use of computational fluid dynamics for simulating hydrodynamics and mass transfer in industrial ozonation towers”, Chem. Eng. Sci., 54 (21), 5085 (1999). (https://doi.org/10.1016/S0009-2509(99)00239-0).
[23]  Moraveji, M. K., and Davarnejad, R., “CFD modeling of geometrical parameters effects on the hydrodynamics and mass transfer in an airlift reactor”, World Appl. Sci. J., 15 (6), 890 (2011).
[24]  Chisti, Y., “Pneumatically agitated bioreactors in industrial and environmental bioprocessing: Hydrodynamics, hydraulics, and transport phenomena”, Appl. Mech. Rev., 51 (1), 33 (1998). (https://doi.org/10.1115/1.3098989).
[25]  Suhaimi, A. and Nasir, N., “Study of the fluid flow pattern in a bubble column reactor for biodiesel production”, Proceedings of IOP Conference Series: Materials Science and Engineering, 1, 012035 (2017).
[26]  Moradi, S., Rajabi, Z., Mohammadi, M., Salimi, M., Homami, S. S., Seydei, M. K. and Shirazian, S., “3 dimensional hydrodynamic analysis of concentric draft tube airlift reactors with different tube diameters”, Math. Comput. Model., 57 (5-6), 1184 (2013). (https://doi.org/10.1016/j.mcm.2012.10.021).
[27]  Wu, W. T. and Wu, J. Y., “Airlift reactor with net draught tube”, J. Ferm. Bioeng., 70 (5), 359 (1990). (https://doi.org/10.1016/0922-338X(90)90152-M).
[28]  Moraveji, M. K., Mohsenzadeh, E., Fakhari, M. E. and Davarnejad, R., “Hydrodynamics and oxygen mass transfer characteristics of petroleum based micro-emulsions in a packed bed split-cylinder airlift reactor”, Braz. J. Chem. Eng., 30 (3), 541 (2013). (https://doi.org/10.1590/S0104-66322013000300012).
[29]  Tunthikul, N., Wongsuchoto, P. and Pavasant, P., “Hydrodynamics and mass transfer behavior in multiple draft tube airlift contactors”, Korean J. Chem. Eng., 23 (6), 881 (2006). (https://doi.org/10.1007/s11814-006-0003-5).
[30]  Jones, S. T. and Heindel, T. J., “Hydrodynamic considerations in an external loop airlift reactor with a modified downcomer”, Ind. Eng. Chem. Res., 49 (4), 1931 (2010). (https://doi.org/10.1021/ie901311r).
[31]  Loomba, V., Huber, G. and von Lieres, E., “Single-cell computational analysis of light harvesting in a flat-panel photo-bioreactor”, Biotechnol. Biofuels, 11 (1), 149 (2018). (https://doi.org/10.1186/s13068-018-1147-3).
[32]  Amini, E., Mehrnia, M. R., Mousavi, S. M. and Azami, H., “Investigating the effect of sparger configuration on the hydrodynamics of a full-scale membrane bioreactor using computational fluid dynamics”, RSC Advances, 5 (127), 105218 (2015). (https://doi.org/10.1039/C5RA18727C).